Dacor DR30GIFSLP Installationsanweisungen

Cooktop Assembly

Never attempt to operate the range’s cooktop with any of 

the burner rings, burner caps or grates removed.

1.  Remove the burner rings, burner caps and grates from 

their shipping cartons.

2.  Install the burners as shown. Gently twist each piece 

back and forth after installation to make sure it is 

properly seated. A small gap below the bottom of the 

burner ring is normal. 

3.  Gently set the grates on top of the spill tray. Put the 

legs of each grate inside the corresponding dimples.

STEP 1: Install dual 

burner ring on dual 

burner base. Line 

up indentations on 

bottom of burner ring 

with pins on top of 

burner base.

STEP 1: Install 

standard burner 

rings on standard 

burner bases. Put 

holes on edge of 

each ring over 

the igniter. Center 

tabs on bottom of 

each ring in hole 

in center of each 

base.

STEP 2: Set outer 

dual burner cap on 

dual burner ring. Make 

sure it is centered on 

top of burner ring.

STEP 2: Install all 

standard burner 

caps. Ridge on 

bottom of caps 

must surround 

top of ring.

STEP 3: Set inner 

dual burner cap on 

center of dual burner 

ring. Line up ridge on 

bottom of cap with 

pins on center of 

burner base.

Pin on burner base

Igniter on burner base

Burner ring

Burner ring - 

top view

Outer burner cap

Inner burner 

cap

Igniter hole

Ridge on bottom

Ridge on bottom 

of burner cap

Installation Instructions