Thermador PRD304GHU Installationsanweisungen

English 11

For 30” and 36” ranges, an anti-tip device must be installed 
as per these instructions.

•

All ranges can tip and injury can result. To 
prevent accidental tipping of the range, 
attach it to the floor, wall or cabinet by 
installing the Anti-Tip Device supplied.

•

A risk of tip-over may exist if the appliance 
is not installed in accordance with these 
instructions.

•

If the range is pulled away from the wall for 
cleaning, service or any other reason, 
ensure that the Anti-Tip Device is properly 
reengaged when the range is pushed back 
against the wall. In the event of abnormal 
usage (such as a person standing, sitting, 
or leaning on an open door), failure to take 
this precaution can result in tipping of the 
range. Personal injury might result from 
spilled hot liquids or from the range itself.

•

Use extreme caution when drilling holes 
into the wall or floor. There may be 
concealed electrical wires located behind 
the wall or under the floor.

•

Identify the electrical circuits that could be 
affected by the installation of the Anti-Tip 
Device, then turn off power to these 
circuits.

•

Failure to follow these instructions may 
result in electrical shock or other personal 
injury.

•

Contact a qualified installer or contractor to determine 
the proper method for drilling holes through the wall or 
floor material (such as ceramic tile, hardwood, etc.)

•

Do not slide the range across an unprotected floor.

•

Failure to follow these instructions may result in 
damage to wall or floor coverings.

•

Screwdriver, Phillips

•

Drill, electric or hand

•

Measuring tape or ruler

•

1/8" drill bit (wood or metal wall or floor)

•

Hammer

•

Pencil or other marker

•

3/16" carbide-tipped masonry drill bit (concrete or 
concrete block wall or floor)

•

3/16" anchors, drywall or concrete, 4 each (not 
required if mounting bracket is being attached to solid 
wood or metal)

For 30” and 36” Dual Fuel Ranges (Figure 6 and 

Figure 7) 

Important Installation Information: 

•

The anti-tip bracket may be attached to a solid wood 
cabinet having a minimum wall thickness of 3/4".

•

The thickness of the wall or floor may require use of 
longer screws, available at your local hardware store.

•

In all cases, at least two (2) of the bracket mounting 
screws must be fastened to solid wood or metal.

•

Use appropriate anchors when fastening the mounting 
bracket to any material other than hard-wood or metal.

-

All Ranges can tip

-

Injury to Persons could result

-

Install Anti-Tip Device

-

See Installation Instructions

415078

4

Screw, Phillips, #10 x 1-1/2"

647936

1

Anti-Tip Bracket, Floor-

Mounted