Maytag MVWC215EW Benutzung Und Pflege

Seite von 36
10
Operate your washer only when you are home. If moving, or not 
using your washer for a period of time, follow these steps:
1.  Unplug or disconnect power to washer.
2.  Turn off water supply to washer, to avoid flooding due to water 
pressure surge.
 
WINTER STORAGE CARE
IMPORTANT: To avoid damage, install and store washer  
where it will not freeze. Because some water may stay in  
hoses, freezing can damage washer. If storing or moving  
during freezing weather, winterize your washer.
To winterize washer:
1.  Shut off both water faucets; disconnect and drain water inlet 
hoses.
2.  Put 1 qt. (1 L) of R.V.-type antifreeze in basket and run  
washer on RINSE & SPIN cycle for about 30 seconds to  
mix antifreeze and remaining water.
3.  Unplug washer or disconnect power.
NON-USE AND VACATION CARE
WASHER MAINTENANCE
Replace inlet hoses after 5 years of use to reduce the risk of hose 
failure. Periodically inspect and replace inlet hoses if bulges, kinks, 
cuts, wear, or leaks are found.
When replacing your inlet hoses, mark the date of replacement on 
the label with a permanent marker.
NOTE: This washer does not include inlet hoses. See the 
“Installation Instructions” for more information.
WATER INLET HOSES
 
 
WASHER CARE
Recommendations to Help Keep Your Washer Clean and 
Performing at its Best
1.
  Always follow the detergent manufacturer’s instructions 
regarding the amount of detergent to use. Never use more than 
the recommended amount because that may increase the rate 
at which detergent and soil residue accumulate inside your 
washer, which in turn may result in undesirable odor.
2.  Use warm and hot wash water settings sometimes (not 
exclusively cold water washes), because they do a better job of 
controlling the rate at which soils and detergent accumulate.
3.  Always leave the washer lid open between uses to help dry out 
the washer and prevent the buildup of odor-causing residue.
Cleaning Your Top Loading Washer
Read these instructions completely before beginning the 
routine cleaning processes recommended below. This Washer 
Maintenance Procedure should be performed, at a minimum, once 
per month or every 30 wash cycles, whichever occurs sooner, 
to control the rate at which soils and detergent may otherwise 
accumulate in your washer.
Cleaning the Inside of the Washer
To keep your washer odor-free, follow the usage instructions 
provided above, and use this recommended monthly cleaning 
procedure:
Recommended Cycle for Cleaning the Washer
Refer to the “Cycle Guide” for the optimal cycle for cleaning the 
inside of the washer. Use this cycle with affresh
®
 Washer Cleaner 
or liquid chlorine bleach as described below.
Begin procedure
1. affresh
®
 Washer Cleaner Cycle Procedure  
 
 
  (Recommended for Best Performance):
a. Open the washer lid and remove any clothing or items.
b. Place an affresh
®
 Washer Cleaner tablet in the bottom of  
the washer basket.
c. Do not place an affresh
®
 Washer Cleaner tablet in the 
detergent dispenser.
d. Do not add any detergent or other chemical to the washer 
when following this procedure.
e. Close the washer lid.
f. Select the cycle recommended for cleaning the inside of  
the washer.
g. Press the START/Pause/Unlock button to start the cycle.
NOTE: For best results, do not interrupt cycle. If cycle must be 
interrupted, press START/Pause/Unlock once or twice (depending 
on model). After the cycle has stopped, run a RINSE & SPIN 
cycle to rinse cleaner from washer.
 
WASHER CARE (cont.)
2. Chlorine Bleach Procedure (Alternative):
a. Open the washer lid and remove any clothing or items.
b. Add 1 cup (236 mL) of liquid chlorine bleach to the bleach 
compartment.
NOTE: Use of more liquid chlorine bleach than is 
recommended above could cause washer damage over time.
c. Close the washer lid.
d. Do not add any detergent or other chemical to the washer 
when following this procedure.
e. Select the cycle recommended for cleaning the inside of the 
washer.
f.  Press the START/Pause/Unlock button to start the cycle.
NOTE: For best results, do not interrupt cycle. If cycle must 
be interrupted, press START/Pause/Unlock once or twice 
(depending on model). After the cycle has stopped, run a 
RINSE & SPIN cycle to rinse cleaner from washer.
Cleaning the Dispensers
After a period of using your washer, you may find some residue 
buildup in the washer’s dispensers. To remove residue from 
the dispensers, wipe them with a damp cloth and towel dry. 
Do not attempt to remove the dispensers or trim for cleaning. 
The dispensers and trim are not removable. If your model has a 
dispenser drawer, however, remove the drawer and clean it before 
or after you run the Clean Washer cycle. Use an all-purpose 
surface cleaner, if needed.
Cleaning the Outside of the Washer
Use a soft, damp cloth or sponge to wipe away any spills.  
Use only mild soaps or cleaners when cleaning external washer 
surfaces.
IMPORTANT: To avoid damaging the washer’s finish, do not use 
abrasive products.