Whirlpool WEE730H0D Installationsanweisungen

Seite von 32
4
Cabinet opening dimensions that are shown must be used. 
Given dimensions are minimum clearances.
The anti-tip bracket must be installed. To install the anti-tip 
bracket shipped with the range, see “Install Anti-Tip Bracket” 
section.
Grounded electrical supply is required. See the appropriate 
“Electrical Requirements” section. 
Contact a qualified floor covering installer to check that the 
floor covering can withstand at least 200°F (93°C). 
Use an insulated pad or ¼" (0.64 cm) plywood under range if 
installing range over carpeting.
IMPORTANT: To avoid damage to your cabinets, check with your 
builder or cabinet supplier to make sure that the materials used 
will not discolor, delaminate or sustain other damage. This oven 
has been designed in accordance with the requirements of UL 
and CSA International and complies with the maximum allowable 
wood cabinet temperatures of 194°F (90°C).
Mobile Home - Additional Installation Requirements
The installation of this range must conform to the Manufactured 
Home Construction and Safety Standard, Title 24 CFR, Part 3280 
(formerly the Federal Standard for Mobile Home Construction 
and Safety, Title 24, HUD Part 280). When such standard is not 
applicable, use the Standard for Manufactured Home 
Installations, ANSI A225.1/NFPA 501A or with local codes.
In Canada, the installation of this range must conform with the 
current standards CAN/CSA-A240-latest edition, or with local 
codes.
Mobile Home Installations Require:
When this range is installed in a mobile home, it must be 
secured to the floor during transit. Any method of securing 
the range is adequate as long as it conforms to the standards 
listed above.
Four-wire power supply cord or cable must be used in a 
mobile home installation. The appliance wiring will need to be 
revised. See “Electrical Connection - U.S.A. Only” section.
Product Dimensions
This manual covers several models. Your model may appear 
different from the models depicted. Dimensions given are 
maximum dimensions across all models.
Model KSEB900
IMPORTANT: Range must be level after installation. Follow the 
instructions in the “Level Range” section. Using the cooktop as a 
reference for leveling the range is not recommended.
*Range can be raised approximately 1" (2.5 cm) by adjusting 
the leveling legs.
A. 1
³⁄₁₆
" (3.0 cm) height from cooktop 
to top of vent
B. 29
⁷⁄₈
" (75.9 cm)
C. Model/serial/rating plate (located 
behind the oven door on the top 
right-hand side of the oven frame)
D. 36" (91.4 cm) height to top of 
cooktop edge with leveling legs 
screwed all the way in*
E. 28
⁵⁄₁₆
" (71.9 cm) max. depth 
from front of console to 
back of range
F. 28
⁷⁄₈
" (73.3 cm) max. depth 
from handle to back of 
range
B
D
A
F
E
C