Dacor DR30GFSNGH Designanleitung

All specifications subject to change without notice.

Phone: (800) 793-0093

www.dacor.com

Document # PG05-007

Revised 04/04/13   Page 2/5

All tolerances +1/16” (+1.6 mm), -0 unless otherwise noted.

30” min.

(76.2 cm)

36” (91.4 cm) recommended

30” (76.2 cm) min.

37” (94.0 cm) 

max.

* See the cutout dimensions on following page for self-rimming installations.

 

■

Failure to meet or exceed the maximum and 

minimum dimensions/clearances stated may result 

in a fire hazard.

 

■

The range should be placed away from drafts that 

may be caused by doors, windows and heating and 

air conditioning outlets.

 

■

To eliminate the risk of burns or fire by reaching 

over heated surface units, cabinet storage space 

located above surface units should be avoided. If 

cabinet storage space is to be provided directly 

above the range, the risk of personal injury may be 

reduced by installing a range hood.

 

■

In all instances, installation of a range hood is highly 

recommended. The hood should project horizontally 

a minimum of five (5) inches beyond the face of 

the cabinets. See the range hood specifications for 

minimum clearances.

 

■

If installing a raised vent, install only Dacor model 

ERV3015.

 

■

The range may be installed flush to the rear wall. 

See diagram and notes for rear wall surface 

requirements. It is not necessary to install non-

combustible materials behind the range below the 

countertop height.

 

■

Any openings in the wall behind the appliance or in 

the floor underneath it must be sealed.

1

 30” (76.2 cm) min. vertical clearance from top of range grates to bottom of uncovered wood or metal cabinet. 24” (61 cm) min. clearance if bottom of 

wood or metal cabinets are protected by not less than 1/4“ (0.6 cm) flame retardant millboard covered with no less than No. 28 MSG sheet steel 0.015” 

(0.04 cm) stainless steel, or 0.024” (0.06 cm) aluminum or 0.020” (0.05cm) copper. 30” (76.2 cm) min. clearance between top of range grates and bottom 

of unprotected wood or metal cabinet. If installing range hood, check the hood specifications for minimum required clearances.

2

 Cabinet/countertop depth is at discretion of customer but cabinet face SHALL NOT protrude further than rear of front panel. See Product Dimensions.

3

 Consult local code and following pages for requirements.

4

 This specification not applicable for cabinets more than a horizontal distance of 10” (25.4 cm) from edge of range.

5

 10” (25.4 cm) min. to combustible sidewalls above range (both sides).

6

 Non-combustible surface required for models DR30GIS and DR30GIFS up to vertical distance specified in note 1 or range hood, whichever is lower. Non-

combustible surface recommended, but not required, for models DR30GS and DR30GFS.

Note 2

Back wall

immediately

behind range

6

Top of

finished

counter

13” (33.0 cm)

max.

4

14” (35.6 cm)

min.

4

Suggested

location of

utilities

3

Note 5

Note 1