Dacor DR30GFSLPH Installationsanweisungen

Installing the Anti-Tip Bracket

Locate the anti-tip bracket included in the parts box.
There are two ways to mount the anti-tip bracket:
•  Floor mounting (preferred method)
•  Wall mounting (alternate method). Use this method if 

floor mounting is not suitable. If any of the conditions 

below exist, then the wall mounting method can not be 

used and the floor mounting method must be suitable.

◊  The wall contains metal stud mounting materials that 

interfere with the anti-tip bracket mounting screws.

◊  The front panel of range is further than the maximum 

distances from the back wall stated on page 11.

◊  The flooring is too thick (see Installing the Anti-Tip 

Bracket on the Wall).

To perform its intended function, the anti-tip bracket 

must be attached as instructed to the concrete slab 

or wood sub-floor below any floor coverings (including 

cement board) on top. Do not attach the anti-tip bracket 

directly to floor coverings such as ceramic/asphalt tile or 

linoleum.

     continued...

Verifying the Package Contents

Unpack the range and verify that all required parts have 

been provided. If any item is missing or damaged, please 

contact your dealer immediately. Do not install a damaged 

or incomplete appliance. The customer must report 

cosmetic issues immediately to the dealer or builder.

Parts List

•

Anti-tip bracket with screws and anchors

•

2 grates

•

Use and care manual

•

Stainless steel cleaner

•

1 dual burner ring

•

1 outer dual burner cap

•

1 inner dual burner cap

•

3 standard burner caps (2 large, 1 small)

•

3 standard burner rings (2 large, 1 small)

•

2 standard oven racks 

•

1 GlideRack oven rack

Installation Instructions

•  If the gas or electric service provided does not meet 

the product specifications, do not proceed with the 

installation. Call the selling dealer, the gas supplier or 

a licensed electrician.

•  This appliance must be installed by a licensed 

plumber or gas fitter when installed within the 

Commonwealth of Massachusetts.

Gas and Electrical Locations

•  Dacor recommends that utility access for all models 

be installed in an adjacent cabinet, as shown on page 

6. If the utilities are installed behind the range, the 

installation must allow for the following:

◊  Access to the gas shut-off valve when the unit is 

installed.

◊  Access to the electrical outlet, when the range is in 

place.

◊  The gas supply piping, gas shut-off valve and the 

electrical outlet must be located so they do not 

interfere with the range when it is installed.

◊  The electrical outlet and gas shut off valve must 

be located so that the range can be pulled out for 

service while the appliance remains connected.

•  Both the gas supply piping and shut-off valve and the 

electrical outlet must be located so they do not interfere 

with the range when it is installed.

 

10” (25.4 cm)

10” (25.4 cm)

12” (30.5 cm)

2 1/2”

(6.4 cm)

3 1/2”

(8.9 cm)

1” (2.5 cm)

•  Existing utility connections may be used for 

replacement purposes, provided they meet local code 

and fit within the utility clearance area at the back of 

the range. See diagram, below.

Installation Specifications