Dacor DR30GFSLPH Installationsanweisungen

1.  Determine the suitability of wall mounting the anti-tip 

bracket. To use the wall mount option, the range front 

panel must not be more than 27 3/8” (69.5 cm) from 

the wall and the bracket screws must be able to thread 

into the base plate inside the wall behind. The notches 

on the sides of the bracket indicate the minimum 

required height of the base plate inside the wall and 

that any floor covering is not too thick for proper screw 

thread engagement.

a.  Determine the location of the range center line 

and front panel when the range is in its final 

position based on the Product Dimensions 

on page 4 and the actual cabinet/cutout 

dimensions used for the installation.

b.  Determine and mark the required position of the 

anti-tip bracket, based on the diagram above. 

Push the bracket up against the wall in the 

mounting location.

c.  Using a pencil, make a dot next to the notches 

on both sides of the bracket. Determine if the 

base plate is as high at the notches by drilling 

test holes into the wall at both dots with a 1/16” 

drill bit. Drill just deep enough to see if the 

bit contacts the base plate. If the bit contacts 

the base plate the location will support wall 

installation of the anti-tip bracket. If you do not 

contact the base plate, or you contact metal stud 

mounting materials, the wall mounting method 

may not be used and the floor mounting method 

must be suitable, or the wall must be modified so 

that the base plate is above the notches.

4.  To install the bracket, place it against the wall in the 

mounting location shown in the diagram, upper right. 

Using a drill with 1/8” diameter drill bit, drill four (4) 1 

5/8” deep pilot holes perpendicular to the screw seating 

surfaces shown, above right. Attach the bracket to the 

wall as shown with the four (4) included #12 x 1 3/4 

screws.

Installation Instructions

CL

CL

Back wall

Bracket

center line

Range

center line

#12 x 1 3/4” 

screw,

4 places

Top hole, indicates

bracket center line

Range

front panel

11 1/2” (29.2 cm)

Cabinet

face below

countertop

26 1/8”  

(66.4 cm) 

to 

27 3/8”  

(69.5 cm)

Backguard Kit Installation

See page 4 for available part numbers and 

compatibility.
If installing a backguard other than the standard size, 

install it before pushing the range into place. Install the kit 

according to the accompanying installation instructions. A 

T-20 Torx driver is required.
NOTE: If installing a raised vent (models DR30GIS and 

DR30GIFS only), do not use a backguard other than the 

standard 1 3/4 inch version installed at the factory.
    continued...

Anti-tip

bracket

Base

plate

Notch

Drywall

Wall