Elica ENM230SS Installationsanweisungen

 

Recommended mounting height is 18” to 24” from the bottom of 

the range hood to the top of the cooking surface.

The hood should be mounted to the bottom of a standard wall 

cabinet. If the hood must be mounted directly to a wall, secure the 

hood to wall studs.
All wiring must comply with local codes and the unit must be 

properly grounded. The hood is connected to a 110 - 120 VAC

lighting circuit (15 Amp) in the circuit breaker or fuse box. 

 

The model 

ESN130 is non-ducted 

The model 

EFS130 is ducted 

The models 

ERS230, ENM230 and ENM236 are convertible (they

may be installed as a ducted or as a non-ducted unit).

Purchase Accesories Recirculation (non ducted) kit  

ERS230: ERSRCK30

ENM230 / ENM236: ENMRCK36

 

Ductwork can be installed vertically or horizontally.

Duct runs should be as short as possible.

Avoid the use of elbows.

Use duct tape at all joints.

Do not use duct smaller than the discharge on the hood.

For 7” round ductwork installation, purchase accessory

transition Kit:

7” (17.8 cm) round vent mounting plate.  

  Accesories Part No. EXXTRK07 (purchased separately).

7” (17.8 cm) round damper Non return valve.  

  Accesorie Part No. EXXNRVRD (purchased separately).
For 3¹⁄

4

” x 10” (8.3 x 25.4 cm) rectangular ductwork  

installation:

3¹⁄

4

”  x  10”  (8.3  x  25.4  cm)  rectangular  vent  conector  is  

  supplied. 

If needed purchase 3¹⁄

4

” x 10” (8.3 x 25.4 cm)  

  rectangular damper non return valve. Accessories  

  Part No. EXXNRVRT

•

•

•

•

•

•

•

•

•

•

•

45° elbow

2.5 ft

(0.8 m)

90° elbow

5.0 ft

(1.5 m)

7” (17.8 cm)

0.0 ft

(0.0 m)

Wall cap

3 " x 10"

(8.3 x 25.4 cm) 

elbow

2 ft

(0.6 m)

6 ft (1.8 m)

1 - 90° elbow

= 5.0 ft (1.5 m)

8 ft (2.4 m) straight

= 8.0 ft (0.0 m)

1 - wall cap

= 0.0 ft (2.4 m)

Length of 3¹⁄

4

” x 10”  

= 13.0 ft (3.9 m)

(8.3 cm x 25.4 cm) system