Elica ENM230SS Installationsanweisungen

Lift the range hood up under cabinet and determine final

location by centering beneath cabinet. Mark on the underside

of cabinet the location of the 4 keyhole mounting slots on the

range hood. Set range hood aside on a covered surface.

Use ¹⁄

” (3 mm) drill bit and drill 4 pilot holes as shown.

Install the 4 - 4.5 mm x 13 mm mounting screws in pilot

holes. Leave about ¹⁄

” (6.4 cm) space between screw heads

and cabinet to slide range hood into place.

Remove transition knockouts depending on your model.

Round vent system installations - Remove top rectangular

and round vent knockouts.
Rectangular vent system installations - For roof

installations, remove the top rectangular vent knockout. For

wall installations, remove the rear rectangular vent knockout
Non-ducted (recirculating) installations - Do not remove

any knockouts.

Remove metal grease filters. See the “Range Hood Care”

section. For the ENM series models, first remove the lateral

panels

NOTE: You will have 3 1/4” x 10” (8.3 x 25.4 cm) rectangular

vent connector inside your range hood. Some models are

recirculation (non-ducted only) and will not have vent

connector.

Remove the 3-1/4” x 10” (8.3 x 25.4 cm) rectangular vent

connector attached with screws or taped on the inside your

range hood.

A. Keyhole slot

A. Drill pilot hole

(6.4 mm)

A. Round vent knockout
B. Top rectangular vent knockout

C. Rear rectangular vent knockout

For round installation: Install 7” (17.8 cm) round vent mounting

plate and damper or 3 1/4” x 10” (8.3 x 25.4 cm) vent

connector, depending on your vent system installation.

(Purchase as an accesory).

A.Screws

B.3 " X 10" (8.3 X 24.4 cm)

rectangular vent connector

model: ENM

models:ESN

EFS

ERS

A. 7" (17.8 cm) Round damper
B. Sheet metal screws

C. 7" (17.8 cm) round vent mounting plate
D. Round vent knockout

E. Rectangular vent knockout

A. Lateral panels

B. 3-1/4” x 10” (8.3 x 25.4 cm)

rectangular vent connector