Maytag MEDB750YW Installationsanweisungen

3-wire receptacle (NEMA 

type 10-30R)

3-prong plug

Spade terminals with 

upturned ends

Ring terminals

Use where local codes permit connecting cabinet-ground 

conductor to neutral wire. 

Connect remaining wires to outer terminal block screws. 

Tighten screws. Finally, reinsert tab of terminal block cover  

into slot of dryer rear panel. Secure cover with hold-down 

screw. Now, go to “Venting Requirements”.

Connect neutral wire (white or center) (C) of power supply cord  

to center terminal block screw (B). Tighten screw.

B

C

Remove center terminal block screw (B).

B

Unscrew the removable conduit connector (A) and any  

screws from a 3/4" (19 mm) UL listed strain relief (UL marking 

on strain relief). Put the threaded section of the strain relief 

(C) through the hole below the terminal block opening (B). 

Reaching inside the terminal block opening, screw the 

removable conduit connector (A) onto the strain relief threads.

C

B

A