Dacor PHW Handbuch

Seite von 12

Cleaning and Maintenance
to remove the Filters:
turn off the main power switch (see page 3 for loca-
tion).
Pull on the release lever 
 A 
 near the bottom of the 
filter and lower it out of the hood. The filters are 
located inside the chimney opening 
 B 
 on the bottom 
of the hood. Remove both filters for cleaning.
1.
2.
Proper cleaning is necessary to ensure safe operation and 
maintain hood performance and appearance. the fre-
quency of cleaning should be adjusted according to the 
type and amount of cooking. Best results will be achieved 
by cleaning soiled components as soon as possible. 
CLeANING STAINLeSS STeeL SuRFACeS
Clean stainless steel surfaces with a mild solution of 
detergent or dishwashing soap and warm water. Rinse and 
dry with a soft, lint-free cloth.
You may also use Dacor Stainless Steel Cleaner on the 
stainless steel surfaces. use it according to the directions 
on the package.
CLeANING THe GLASS
Use a mild glass cleaner to remove finger prints on glass 
surfaces. You can also clean glass surfaces with  
Dacor Cook top Cleaning Creme. use it according to the 
directions on the package. 
CLeANING THe FILTeRS
Clean the filters a minimum of every two months; clean 
them sooner if grease begins to build up on them.
Cleaning
b
a
 warning
to prevent electric shock or damage to the blower, 
thoroughly dry the filters before reinstalling them 
after cleaning.
to prevent electric shock turn off the main power 
switch (see page 3) before cleaning the range hood 
or filters.
Clean the hood only in the manner specified.
to avoid dangerous fumes or damage to your hood’s 
surfaces, use only the types of cleaning solutions 
specified in this manual. 
to avoid personal injury, turn off the cooktop or 
range and make sure that the appliance and range 
hood are cool before cleaning.
Always wipe stainless steel (silver colored) surfaces 
with the grain. to prevent scratching, do not use 
abrasive cleaners or scrubbers on stainless steel or 
glass surfaces.
to avoid damage to the blower, do not reinstall 
damaged or worn filters (see page 6 for 
replacement part numbers).

to Clean the Filters:
Hand wash the filters in hot water with a mild detergent 
solution or place them in an automatic dishwasher. Dry 
the filters completely before reinstalling them.
to reinstall the Filters:
Insert the end of the filter opposite the release lever 
into the slot right next to the light and main switch 
panel. the release lever must be facing out.
Pull on the release lever while sliding the bottom end 
of the filter into the filter opening.
Release the lever.
1.
2.
3.