Whirlpool WEG730H0DB Installationsanleitung

Seite von 48
14
Repeat steps 1 to 3. If the burner does not light at this point, 
press the off pad and contact your dealer or authorized service 
company for assistance. Please reference the “Warranty” section 
of the User Guide to contact service
If the bake burner flame needs to be adjusted, see the “Adjust 
Flame Height” section.
Refer to the User Guide for proper operation of the oven controls.
Check Operation of Oven Broil Burner
1. Close the oven door.
2. Press BROIL.
3. Press the Start pad.
The oven burner should light within 8 seconds. The first time 
a burner is lit, it may take longer than 8 seconds to light 
because of air in the gas line.
4. After 2 minutes, open the oven door and check that the oven 
is warm.
If Burner Does Not Light Properly:
Press the Off pad.
Check that the range is plugged into a grounded 3 prong 
outlet. Check that the circuit breaker has not tripped or the 
household fuse has not blown. 
Check that the gas shutoff valves are set to the open 
position. 
Repeat steps 1 to 3. If the burner does not light at this point, 
press the off pad and contact your dealer or authorized service 
company for assistance. Please reference the “Warranty” section 
of the User Guide to contact service
If the broil burner flame needs to be adjusted, see the “Adjust 
Flame Height” section.
Refer to the User Guide for proper operation of the oven controls.
Remove/Replace Drawer
(on some models)
Remove all items from inside the baking drawer, warming drawer 
or premium storage drawer, and then allow the range to cool 
completely before attempting to remove the drawer.
To Remove:
1. Open the drawer to its fully open position.
2. Using a flat-blade screwdriver, gently loosen the drawer from 
the glide alignment notch, and then lift up the drawer 
alignment tab from the glide.
3. Repeat Step 2 on the other side. The drawer is no longer 
attached to the drawer glides. Using both hands, pick up the 
drawer to complete the removal.
To Replace:
1. Align the forward drawer notches with the notches in the 
drawer glides on both sides. Place the rear alignment tabs 
into the drawer glides on both sides.
2. Push the drawer in all the way.
3. Gently open and close the drawer to ensure it is seated 
properly on the glides on both sides.
Oven Door
For normal range use, it is not suggested to remove the oven 
door. However, if removal is necessary, make sure the oven is off 
and cool. Then, follow these instructions. The oven door is heavy.
To Remove:
1. Open oven door all the way.
2. Pinch the hinge latch between two fingers and pull forward. 
Repeat on other side of oven door.
3. Close the oven door as far as it will shut.
4. Lift the oven door while holding both sides.
Continue to push the oven door closed and pull it away from 
the oven door frame.
A. Flat-blade screwdriver
B. Drawer alignment tab
C. Drawer glide notch
C
A
B
A. Drawer alignment tab
B. Drawer glide notch
A. Hinge latch
A
B
A