Dacor RNR30NC Installationsanweisungen
6
Installation Specifications
Rear wall or
countertop edge
countertop opening
29 1/4” (74.3 cm)
30 1/16” (76.2 cm)
cabinet opening
below countertop
below countertop
Cabinet face
Notch countertop
to width of cabinets
3/8” min. (9.5 mm)
countertop overhang
1” min. (2.6 cm)
to any combustibles
above counter both sides
20”
(50.8 cm)
to
23”
(58.4 cm)
20”
(50.8 cm)
Countertop front
Max.
overhang
1 5/8”
(4.1 cm)
Rear wall or
countertop edge
countertop opening
29 1/4” (74.3 cm)
30 1/16” (76.2 cm)
1
cabinet opening
below countertop
below countertop
Cabinet face
Notch countertop
to width of cabinets
3/8” min. (9.5 mm)
countertop overhang
1” min. (2.6 cm)
to any combustibles
above counter both sides
23”
(58.4 cm)
Max.
overhang
1 5/8”
(4.1 cm)
Countertop front
Top View - Slide-In, Self-Rimming Installation,
3” Side Panels Installed - Cabinet Depths 20 3/8” to 23 3/8”
Top View - Slide-In, Self-Rimming Installation,
3” Side Panels Removed - Min. Required Cabinet Depth: 23 3/8”
Cabinet Cutouts for Self-Rimming Installation (Models RNR30NIS and RNR30NIFS Only)
1
To create a “built-in look” on the front of the cabinet,
this dimension may be changed to 29 1/4” (74.3 cm),
with the width at the notches remaining 30 1/16”.
This configuration is only for models RNR30NIS and
RNR30NIFS with the side panels behind the door
removed.
•
The self-rimming installation of the RNR30NI[F]S range
creates a “built-in” look where the range trim overlaps
and rests on the countertop on both sides and in back.
•
Observe all vertical cabinet clearances on page 5.
•
On self-rimming installations when sliding the range into
position, it will stop when the rear of the control panel or
side panels contact the notches toward the front of the
countertop.
34 3/4”
(88.3 cm)
to
36 7/8”
(93.7 cm)
(see diagrams)
Countertop
1 5/8 (41.1 cm)
max. thickness
Cutout tolerances: +1/16” (+1.6 mm), -0, unless otherwise stated.