Gaggenau DF251761 Benutzeranleitung

en-us    Operating the Dishwasher

1

Operating the Dishwasher

Note: With hidden controls, the door must be opened 
before changing settings and closed after changing 
settings.

9

To avoid risk of  injury, always use caution when 
opening the door during or following a wash cycle 
as hot water or steam may escape.  Do not fully 
open the door until water noises have stopped 
and steam has subsided.

Your dishwasher is equipped with a function that helps 
to prevent unintentional operation, for example by 
children. 

After setting the dishwasher the appliance door has to 
be closed within 4  seconds, otherwise the operation will 
be paused. There will be a signal on the control panel 
advising you to press the Start button again and close 
the door.

This function will be activated when:

▯

pressing Start to begin a wash cycle

▯

setting Delay time and pressing Start

▯

opening the door while Delay time is active

▯

opening the door during a wash cycle.

Note: This function cannot be deactivated.

Buttons are sensitive and should be touched gently. 
Avoid any grease or food particles resting on the 
buttons as they could activate the dishwasher.

Wiping and cleaning can also activate the dishwasher. 
For best results, use bare, clean hands when touching 
the buttons.

To clean the touch buttons wipe them with a dry or 
slightly damp cloth.

To open the door, press the upper middle part of the 
door. The appliance opens automatically.

The dishwasher has been preset with certain settings 
for your convenience. You can change these factory 
settings.

Open the door.

Switch on ON/OFF button (.

Press Info button ( 8 for 3 seconds until the 
following text is indicated in the digital display @:

Scroll with < >

Leave with t 3 sec.

Keep pressing button > )* until the required setting 
is indicated in the digital display @.

Make the selection with setting buttons + - X.

Press and hold the Info button ( 8 for 3 seconds. 

The chosen setting has now been stored.

Tip: If you change several settings, first make all 
changes in succession. Now press the Info button ( 8 
for 3 seconds. This saves all set values in the appliance.

The AquaSensor is an optical measuring device (light 
barrier) which measures the turbidity of the rinsing 
water.

The AquaSensor is used according to the wash cycle. If 
the AquaSensor is active, “clean” rinsing water can be 
transferred to the next rinse bath and water 
consumption can be reduced by 3–6 litres. If 
the turbidity is greater, the water is drained and 
is replaced with fresh water. In the automatic wash 
cycles the temperature and running time can also be 
adjusted to the degree of soiling.

* optional feature which may or may not be included with 
your dishwasher