Gaggenau DF251761 Benutzeranleitung

  Operating the Dishwasher    en-us

The wash cycle time is determined during the wash 
cycle by the water temperature, the amount of dishes, as 
well as the degree of soiling and may vary (depending 
on the selected wash cycle). You can change the time 
display into time of day or hours/minutes so that the 
remaining cycle time of the wash cycle appears in the 
display window “Ready at” (for example 15:20 o’clock) 
or “Ready in” (for example 3:25 hours).

The wash cycle sequence is optmised in Auto wash 
cycles with the aid of sensors. The sensors adjust the 
wash cycle strength of Auto wash cycles depending on 
the amount and type of soiling. You can adjust the 
sensitivity of the sensors in 3 stages.

Standard: This setting is ideal for a mixed load and 
heavily soiled utensils, but also saves energy and water. 

Sensitive: This setting adjusts the wash cycle strength 
for the effective removal of food remnants, even if the 
amount of soiling is low. The energy and water 
consumption is adjusted accordingly.

Very sensitive: This setting adjusts the wash cycle 
strength for difficult conditions of use, for example 
firmly dried on food remnants. This setting is 
recommended if using biological or eco detergents 
which contain lower amounts of active agents. The 
energy and water consumption is adjusted accordingly.

The final rinse uses a higher temperature which 
improves the drying result. The cycle time may increase 
slightly. (Caution if utensils are delicate!) You can 
switch the extraDry function on or off.

When Eco forecast is activated, the average water and 
energy consumption of the selected wash cycle is 
briefly displayed in the digital display @. 

To save energy, the dishwasher is switched off 1 minute 
after the wash cycle ends. You can also change this 
setting.

▯

off: The appliance does not switch off automatically.

▯

After one minute: The appliance switches off after 
1 minute.

▯

After two hours: The appliance switches off after 
2 hours.

While the wash cycle is running, a light spot shines 
on the floor under the appliance door. Do not open the 
appliance door until the light point is no longer visible 
on the floor. If the appliance door is not completely 
closed, the light spot flashes *. If the appliance 
is installed at eye-level, with flush furniture front, 
the light point is not visible. You can switch the Infolight 
on or off.

* optional feature which may or may not be included with 
your dishwasher

You can change the “Start wash cycle” setting.

The end of the wash cycle is indicated by a buzzer. You 
can also change this setting.

When you are operating the dishwasher, a signal 
sounds whenever a button is pressed. You can control 
the volume of the signal. If you do not like the button 
volume, you can switch it off.