Gaggenau DF251761 Benutzeranleitung

Seite von 96
37
 Troubleshooting  en-us
Silverware not dry.
Silverware not arranged properly in 
the silverware basket.
Separate silverware if possible, prevent 
contact points.
Silverware not arranged properly in 
the third rack.
Arrange silverware properly and separate if 
possible.
Appliance interior wet after rinse 
cycle.
No appliance fault.
On account of the “Condensation drying” 
principle, water droplets are physically 
induced and required in the container. The 
humidity in the air condenses on the inner 
walls of the dishwasher, drains and is 
pumped out.
Food soils on the dishes.
Dishes placed too closely together, 
racks overfilled.
Arrange dishes with adequate clearance 
between them ensuring that the spray jets 
can reach the surface of the dishes. 
Prevent contact points.
Spray arm rotation obstructed.
Arrange dishes so that the spray arm can 
rotate without obstruction.
Spray arm nozzles are blocked.
Clean the spray arm nozzles. 
Filters 1Z dirty.
Clean filters. 
Filters 1Z inserted incorrectly and/
or not engaged.
Insert and engage filters correctly.
Rinse wash cycle too weak.
Select a more intensive rinse cycle.
Increase sensitivity of the sensors. 
Dishes precleaned too intensely; 
sensors therefore decide on weak 
wash cycle sequence. Stubborn 
soiling cannot be completely 
removed.
Do not prerinse dishes. Remove only large 
food soils.
Increase sensitivity of the sensors. 
Recommended wash cycle "Regular" or 
Intensive.
Tall narrow containers in corner 
areas are not rinsed adequately.
Do not place hollow containers too 
obliquely and do not place in the corner 
area.
Upper rack 12 on right and left not 
set to same height.
Set upper rack to same height using side 
levers.
Dishwasher seems to run a long 
time
Incoming water is not warm enough.
Before starting a cycle, run hot water faucet 
at the sink closest to the dishwasher.
Cycle time can vary due to soil and 
water conditions.
Sensors in the dishwasher automatically 
increase the cycle time to ensure a good 
wash when heavy soil is detected.
Rinse aid dispenser 9" is empty.
Add rinse aid.
Dishwasher connected to cold water 
supply.
Note:Check the typical wash cycle
length. 
Verify dishwasher is connected to hot water 
supply plumbing.
Fault
Cause
Remedial action