Gaggenau DF251761 Benutzeranleitung

en-us    Troubleshooting

Error code “:ƒ… is lit.

Waste-water hose kinked or blocked. Install hose without kinks, remove any 

residue.

Siphon connection still sealed.

Check connection to siphon and open if 
required.

Cover on the drain pump loose.

Lock cover correctly. 

Error code “:ƒ† is lit.

Drain pump blocked or cover on the 
drain pump is not locked in position.

Clean pump and lock cover correctly. 

Error code “:ƒˆ is lit.

Mains voltage too low.

Not an appliance fault, have the mains 
voltage and electrical installation checked.

A different error code is 
indicated on the digital display.
(“:‹‚ to “:„‹)

A technical fault has probably 
occurred.

Switch off appliances with the ON/OFF 
switch (. After a short time restart the 
appliance.
If the problem recurs, turn off the tap and 
pull out the mains plug. 
Call customer service and mention the error 
code.

Refill indicator for salt P and/
or rinse-aid H is lit.

No rinse aid.

Refill rinse aid.

No salt.

Refill with special salt.

Sensor does not detect salt tablets.

Use different special salt.

Refill indicator for salt P and/
or rinse-aid H is not lit.

Refill indicator switched off.

Activation/deactivation ~ ",

There is still enough special salt/
rinse aid available.

Check refill indicator, levels.

Water is left in the appliance at 
the end of the wash cycle.

Filter system or area under the filters 
1Z is blocked.

Clean filters and area underneath.

Wash cycle has not ended yet.

Wait until wash cycle ends or reset. 

Dishes not dry.

No or too little rinse aid in the 
dispenser.

Refill rinse aid.

Wash cycle selected without drying.

Select wash cycle with drying. 

Water collecting in depressions on 
the dishes and silverware.

Arrange dishes in a sloping position, 
arrange affected dishes as sloping as 
possible.

The combined detergent used has a 
poor drying performance

Use different combination detergent with 
better drying performance. Use of rinse aid 
also increases the drying performance.

extraDry to increase drying not 
activated.

Activate extraDry. 

Dishes were removed too early or 
drying process had not ended yet.

Wait until wash cycle ends or wait until 30 
min after wash cycle ends before removing 
dishes.

The eco rinse aid used has a limited 
drying performance.

Use a proprietary rinse aid. Eco products 
may have limited effectiveness.

Plastic dishes not dry.

Special properties of plastic.

Plastic has a lower heat storage capacity 
and therefore dries less well.