Perlick HP15TS31RA Installationsanweisungen
PERLICK RESIDENTIAL INSTALLATION MANUAL FOR BEER DISPENSING EQUIPMENT
4
perlick.com
INSTALLATION OF DISPENSING EQUIPMENT
Open the tapping kit box and become familiar with
its components. If the dispensing head is going to be
mounted on a counter top directly above the refrigerated
cabinet, have the counter top pre-drilled using the
supplied template on page 11. Make sure that the access
hole in the refrigerated cabinet is in line with the counter
top holes. Remove any obstructions from the access hole
of the refrigerator.
Follow instructions on pages 4 through 10 to properly
install the tapping equipment on your perlick unit, or watch
our Beer Dispenser Tapping Installation video. Information
on how to access this video can be found to the right.
Scan the QR code with your
mobile device to watch the
video instantly.
Use the following web link to view the video
through your browser window:
http://youtu.be/
NCKP6x2zZmo
NOTE: Wash tapping devices thoroughly. Flush
beer and faucet lines, as well as the tapping device
(keg coupler) with fresh water.
beer and faucet lines, as well as the tapping device
(keg coupler) with fresh water.
IF YOU ARE INSTALLING A DRAFT ARM - SKIP TO PAGE 6. THE FOLLOWING INSTRUCTIONS ARE ADDITIONAL
PREPARATION STEPS FOR THE ADARA DISPENSING HEAD ONLY
1. Mark the air tube for correct length dependent upon your installation scenario. If installing directly on top of the
refrigerated cabinet, make a mark 5 inches from the bottom of the tower (Figure 1). If installing directly on top of a
countertop, add the depth of the countertop to the original 5 inches and mark at that new dimension (Figure 2).
Figure 1.
Figure 2.