Maytag MEDP475EW Installationsanweisungen

E
F

D

C

B

A

Before you start, disconnect power. Remove hold-down  

screw (D) and terminal block cover (A).

Put power supply cord through the strain relief. Be sure that 

the wire insulation on the power supply cord is inside the 

strain relief. The strain relief should have a tight fit with the 

dryer cabinet and be in a horizontal position. Do not further 

tighten strain relief screws at this point.

A

B

C

D

Remove the screws from a 3/4" (19 mm) UL listed strain relief 

(UL marking on strain relief). Put the tabs of the two clamp 

sections (C) into the hole below the terminal block opening 

(B) so that one tab is pointing up (A) and the other is pointing 

down (D), and hold in place. Tighten strain relief screws just 

enough to hold the two clamp sections (C) together.

Go to 4-Wire Power Supply Cord  

Connection on page 8.

Go to 3-Wire Power Supply Cord  

Connection on page 8.