Frigidaire FGEF306TPF Installationsanweisungen
4
30" ELECTRIC RANGE INSTALLATION INSTRUCTIONS
Range side
Slide
rang
e
bac
k
figure 3
figure 2
figure 5
Leg
Leveler
Raise
Lower
b. drill Pilot Holes and fasten bracket -
Drill
a 1/8" pilot hole where screws are to be located. If
bracket is to be mounted to the wall, drill pilot hole at
an approximate 20° downward angle. If bracket is to be
mounted to masonry or ceramic floors, drill a 3/16" pilot
hole 1-3/4" deep. The screws provided may be used in
wood or concrete material. Use a 5/16" nut-driver or flat
head screwdriver to secure the bracket in place.
bracket is to be mounted to the wall, drill pilot hole at
an approximate 20° downward angle. If bracket is to be
mounted to masonry or ceramic floors, drill a 3/16" pilot
hole 1-3/4" deep. The screws provided may be used in
wood or concrete material. Use a 5/16" nut-driver or flat
head screwdriver to secure the bracket in place.
figure 4
C. Level and position the range
- Slide range
to its final position. Insert the range leveling leg in the
anti-tip bracket. Visually verify if the anti-tip bracket is
engaged. Lower the range by adjusting the 4 leveling
legs alternatively until the range is level. Check if the
range is level by placing a spirit level on the oven rack.
Take 2 readings with the spirit level placed diagonally;
take a reading in one direction and then in the other
direction. Level the range if necessary by adjusting the
leveling legs.
anti-tip bracket. Visually verify if the anti-tip bracket is
engaged. Lower the range by adjusting the 4 leveling
legs alternatively until the range is level. Check if the
range is level by placing a spirit level on the oven rack.
Take 2 readings with the spirit level placed diagonally;
take a reading in one direction and then in the other
direction. Level the range if necessary by adjusting the
leveling legs.
FASTEN BRACKET
(WALL OR FLOOR MOUNTING)
FASTEN BRACKET
(FLOOR MOUNTING ONLY)
Leveling leg
Wall mount
Floor Mount
Anti-Tip Bracket
Rear of Rang
e
1-1/4” Max.
Wall Plate
Wall
More than
1-1/4”
Leveling leg
Floor Mount
Anti-Tip Bracket
Rear of Rang
e
4. Serial Plate Information
The serial plate is located as shown. See the serial
plate for the following information:
A. Model, lot and serial number of range.
B. Kilowatt rating (power requirements).
C. Voltage ratings.
B. Kilowatt rating (power requirements).
C. Voltage ratings.
figure 6