Maytag MRT318FZDM Benutzeranleitung

Your model may have some or all of these features. 

The door rails may be removed for easier cleaning.

1. Depending on your model, remove the rails by pushing in 

slightly on the front of the bracket while pulling out on the 
inside tab. Repeat these steps for the other end.

2. Replace the rails by aligning the ends of the brackets with the 

buttons on the sides of the door liner. Firmly snap bracket 
and assembly onto the tabs above the shelf as shown. 

1. Remove the bin by lifting it and pulling it straight out.

2. Replace the bin by sliding it in above the desired support and 

pushing it down until it stops.

The utility compartment may be removed for easier cleaning.

1. Remove the utility compartment by squeezing against one 

side while raising the utility compartment up and pulling it 
straight out. 

2. Replace the utility compartment by positioning one side in 

the lock and sliding in the opposite side until it stops. 

IMPORTANT: For models with a water filter, after connecting the 
refrigerator to a water source or replacing the water filter, fill and 
discard three full containers of ice to prepare the water filter for 
use. 

To turn ON the ice maker, simply lower the wire shutoff arm.

To manually turn OFF the ice maker, lift the wire shutoff arm to the 
OFF (arm up) position and listen for the click.

NOTE: Your ice maker has an automatic shutoff. As ice is made, 
the ice cubes will fill the ice storage bin and the ice cubes will 
raise the wire shutoff arm to the OFF (arm up) position. Do not 
force the wire shutoff arm up or down.

1. Wash the ice storage bin with mild soap and warm water.

2. Slide the ice storage bin under the ice maker, and push it 

toward the back as far as it will go.

3. Lower the arm on the ice maker to the ON position. 

NOTE: It usually takes approximately 24 hours for the ice 
maker to begin producing ice. You may notice the ice has an 
“off-taste.” If so, discard the first three batches of ice 
produced. After that the “off-taste” should be gone.

■

The ice maker should produce approximately 8 to 12 batches 
of ice in a 24-hour period. Allow 3 days to completely fill the 
ice container. 

■

To increase ice production, lower the freezer and refrigerator 
temperature. See “Using the Control(s).” Wait 24 hours 
between adjustments.

■

The quality of your ice will be only as good as the quality of 
the water supplied to your ice maker. Avoid connecting the 
ice maker to a softened water supply. Water softener 
chemicals (such as salt) can damage parts of the ice maker 
and lead to poor quality ice. If a softened water supply cannot 
be avoided, make sure the water softener is operating 
properly and is well maintained.

■

Do not use anything sharp to break up the ice in the bin. This 
can cause damage to the ice storage bin and the dispenser 
mechanism.

■

Do not store anything on top of or in the ice maker or ice 
storage bin.