GE AVM4160DFBS Installationsanweisungen

  Remove the screws holding the blower unit and 

the screws securing the blower plate. Remove 

the blower plate from the outer case by sliding it 

toward the back of the microwave and pulling up.

Blower Plate

Blower Motor Screws

Blower 

Motor 

Screw

2  Carefully pull out the blower unit. The wires will 

extend far enough to allow you to adjust the 

blower unit.

  Roll the blower so that fan blade openings are 

facing the top of the oven. Place the blower back 

into the opening.

  Slide the blower plate back onto the microwave 

by placing the side tabs into the slots and pushing 

gently until the back tab is seated into the rear slot. 

Replace 3 screws.

Note: Make sure the wires remain routed through the 

openings in the motor frame. To avoid damage to 

the fan motor wiring, insert motor carefully such that 

the fan motor wiring does not contact the microwave 

power cord bracket.

Back of 
Mircrowave

Rotate 90°

 5LVNRI(OHFWULF6KRFN 

Side Tab

Side Slot

Rear Slot

Rear Tab

Back of  

Mircrowave

Fan Blades

Wires