GE AVM4160DFBS Installationsanweisungen

LQMXU\EDFNLQMXU\RURWKHULQMXULHVGXHWRH[FHVVLYH
ZHLJKWRIWKHPLFURZDYHRUSURSHUW\GDPDJH\RX
ZLOOQHHGWZRSHRSOHWRLQVWDOOWKLVPLFURZDYH
IMPORTANT: Do not grip or use handle during 

installation.

 5LVNRI(OHFWULF6KRFN&DQ

IMPORTANT: If filler blocks are not used, case damage 

may occur from overtightening screws.

NOTE: When mounting the microwave, thread power 

cord through hole in bottom of top cabinet. Keep it 

tight throughout Steps 1–3. Do not pinch cord or lift 

microwave oven by pulling cord.

Lift microwave, tilt it forward, and hook slots at 

back bottom edge onto four lower tabs of mounting 

plate.

Rotate front of microwave oven up against cabinet 

bottom. 

Power Cord

Filter (dashed to show 

details of groves)

Bottom Tab

Grooves in 

Microwave for 

Filter on Each Side

Remove 2 screws on top of microwave oven, just 

above the grille panel, using a Phillips screwdriver. 
If two screws are not accessible, see section A5.
Open the door.
Remove the grille.

Insert the top of the filter up and into the grooves on 

both sides of the inside of the top opening. Once you 

have cleared the bottom tab, push the bottom of the 

filter in until it rests in place behind the tab.  

Replace the grille by inserting the top grill flange 

into the slots in the case as shown. 

Replace the 2 top screws.

Close the door.

Grille

Grille

Grille

Ensure bottom 

tabs are seated  

as shown.