Frigidaire FFGS3025PS Installationsanweisungen

Range

Anti-Tip Bracket

Floor Mount

Screws

Rear

of

Range

Wall

1.  Draw a center line (CL) on the floor where the range 

should be installed. Also draw a line on the floor at 

the range back position if there is no wall.

2.  Unfold paper template and place it flat on the floor 

with the right rear corner positioned exactly on the 

intersection of the center and back lines you just 

drew before. (Use the diagram below to locate 

brackets if template is not available (Figure 18)).

3.  Mark on the floor the location of the 4 mounting holes 

shown on the template. For easier installation, 3/16" 

(0,48 cm) diameter pilot holes 1/2" (1,27 cm) deep 

can be drilled into the floor.

4.  Remove template and place bracket on floor. Line up 

holes in bracket with marks on floor and attach with 

4 screws provided. Bracket must be secured to solid 

floor (Figure 19). If attaching to concrete floor, first 

drill 3/16" (0,48 cm) dia. pilot holes using masonry 

drill bit.

5.  Be sure the 4 leveling legs are at the highest position 

they can be.

6.   Slide range into place making sure structure of the 

range is trapped by the anti-tip bracket (Figure 19). 

Lower the range by adjusting the 4 leveling legs until 

the underside of the cooktop is sitting level on the 

countertop. Refer to "Leveling the Range" section.

7.  After installation, verify that the anti-tip bracket is 

engaged by grasping the top rear edge of the range 

and carefully attempt to tilt it forward to make sure 

range is properly anchored.

 To reduce the risk of tipping of the range, 

the range must be secured to the floor by properly installed 

anti-tip bracket and screws packed with the range. These 

parts are located in the oven. Failure to install the anti-tip 

bracket will allow the range to tip over if excessive weight 

is placed on an open door or if a child climbs upon it. 

Serious injury might result from spilled hot liquids or from 

the range itself.

 

Follow the instructions below to install the anti-tip 

brackets.
If range is ever moved to a different location, the anti-

tip brackets must also be moved and installed with the 

range.
Tools Required:

Adjustable Wrench

Ratchet

Drill & 1/8" (0,32 cm) bit

5/16" (0,8 cm) Nutdriver

Level

The anti-tip bracket attaches to the floor at the back of 

the range to prevent range from tipping. When fastening 

bracket to the floor, be sure that screws do not penetrate 

electrical wiring or plumbing. The screws provided will 

work in either wood or concrete.