Maytag MEDX6STBW Installationsanweisungen

Connect neutral ground wire (E) and neutral wire (white or 

center wire) (C) of power supply cord or cable under center 

terminal block screw (B). Tighten screw.

Venting

Place hooked ends of remaining wires under outer terminal 

block screws (hooks facing right). Tighten screws. 

Connect a separate copper ground wire (G) from the external 

ground conductor screw (A) to an adequate ground. Finally, 

reinsert tab of terminal block cover into slot of dryer rear 

panel. Secure cover with hold-down screw. Now, go to 

Venting Requirements. 

To reduce the risk of fire, this dryer MUST BE 

EXHAUSTED OUTDOORS.

Observe all governing codes and ordinances.

Dryer exhaust must not be connected into any gas vent, 

chimney, wall, ceiling, attic, crawlspace, or a concealed space 

of a building. Only rigid or flexible metal vent shall be used for 

exhausting.

 

■

Only a 4" (102 mm) heavy metal exhaust vent and clamps may 

be used. 

 

■

Do not use plastic or metal foil vent.

 

■

Recommended for best drying performance and to avoid 

crushing and kinking.

(Acceptable only if accessible to 

clean)

 

■

Must be fully extended and supported in final dryer location.

 

■

Remove excess to avoid sagging and kinking that may result 

in reduced airflow and poor performance.

 

■

Do not install in enclosed walls, ceilings, or floors.

 

■

The total length should not exceed 7

3

/

4

 ft. (2.4 m).

If using an existing vent system, clean lint from entire 

length of the system and make sure exhaust hood is not plugged 

with lint. Replace plastic or metal foil vents with rigid metal 

or flexible metal vents. Review “Vent System Chart” and, if 

necessary, modify existing vent system to achieve best drying 

performance.