Sterling 882.00379.00 Benutzerhandbuch
Conveying System Mechanical Components Chapter 5: Maintenance
92 of 138
5-5 Cleaning/Replacing the Filter Cartridge
SFC-S
Use the following procedure to clean or replace the filter cartridge:
1. Unlatch the four (4) clamps that hold the collection bin to the filter assembly.
2. Discard contents of the collection bin if needed.
3. Loosen and remove the wing bolt that holds the filter cartridge in place.
4. Remove the filter cartridge from the assembly.
5. Use compressed air to clean the filter cartridge. Blow from the inside to the outside of
2. Discard contents of the collection bin if needed.
3. Loosen and remove the wing bolt that holds the filter cartridge in place.
4. Remove the filter cartridge from the assembly.
5. Use compressed air to clean the filter cartridge. Blow from the inside to the outside of
the filter cartridge. Make sure that the compressed air pressure is less than 100 PSI
(6.9 Bar) to keep from damaging the filter. Replace the filter cartridge if it shows
signs of wear.
(6.9 Bar) to keep from damaging the filter. Replace the filter cartridge if it shows
signs of wear.
6. Wipe down the gaskets on the filter cartridge and on the filter assembly where the
collection bin will meet.
7. Re-install the filter cartridge. Make sure the filter cartridge is properly seated in the
housing, and bolt it into the assembly.
8. Replace the collection bin and re-latch the clamps that hold it into place.
Spare Parts
Filter Cartridge: A0571262
SFC 225 and SFC 1000
Use the following procedure to clean or replace the filter cartridge:
1. Unlatch the clamp that secures the cover assembly.
2. Lift off the cover.
3. Unscrew the retaining cover, and remove the filter cartridge.
4. Use compressed air to clean the filter cartridge. Blow from the inside to the outside of
the filter cartridge. Make sure that the compressed air pressure is less than 100 PSI
(6.9 Bar) to keep from damaging the filter. Replace the filter cartridge if it shows signs
of wear.
5. Wipe down the gasket and filter retainer cover mating surfaces to ensure a good seal.
6. Re-install the filter cartridge. Make sure the filter cartridge is properly seated in the
housing.
7. Re-install the retaining cover. A snug fit is required for a proper fit. Do not over
2. Lift off the cover.
3. Unscrew the retaining cover, and remove the filter cartridge.
4. Use compressed air to clean the filter cartridge. Blow from the inside to the outside of
the filter cartridge. Make sure that the compressed air pressure is less than 100 PSI
(6.9 Bar) to keep from damaging the filter. Replace the filter cartridge if it shows signs
of wear.
5. Wipe down the gasket and filter retainer cover mating surfaces to ensure a good seal.
6. Re-install the filter cartridge. Make sure the filter cartridge is properly seated in the
housing.
7. Re-install the retaining cover. A snug fit is required for a proper fit. Do not over
tighten the retaining cover.
8. Place the cover on top of the filter assembly
9. Latch the clamp that secures the cover assembly.
9. Latch the clamp that secures the cover assembly.
Spare Parts
XFC 225 Filter Cartridge:
XFC 225 Filter Cartridge:
A0547008
XFC 1000 Filter Cartridge:
A0547007