KitchenAid 1954 Installationsanweisungen

•  Locate gas supply shut 

off valve on the pressure 

regulator.

•  Shut off gas supply before 

converting to L.P. gas.

•  Make all conversions 

before turning gas supply 

valve back on.

Failure  to  follow  these  instructions  could  result  in  fire, 

exposion or other personal injury.

A. PlAstic cover
B.  GAs Pressure reGulAtor cAP with solid end  

fAcinG out

c.  GAs Pressure reGulAtor cAP with hollow  

end fAcinG out

d.  wAsher
e.  GAs Pressure reGulAtor cAP

•  Remove storage drawer. See page 17.
•  Locate  the  regulator  at  the  rear  of  storage  drawer 

compartment.

•  Remove the plastic cover from the regulator cap.
•  With your fingers, turn the nut counter clockwise.
•  Do not remove the spring beneath the cap.
•  Turn the cap over so LP faces up and reinstall into regulator.
•  Replace plastic cover over regulator cap.

 1.  Remove oven racks.
 2.  Use  a  1/2”  combination  wrench  to  tighten  the  orifice 

hood toward the pin (about 2 to 2-1/2 turns). The oven 
bake  burner  flame  cannot  be  properly  adjusted  if  this 
conversion is not made.

A. orifice hood
B. Pin
c.  nAturAl GAs: increAse GAs – increAse flAme size (Preset 

At fActory for nAturAl GAs)

d.  lP GAs: decreAse GAs, deGreAse flAme size.

 1.  Use  a  1/2”  combination  wrench  to  tighten  the  orifice 

hood  toward  the  pin  (about  2  to  2-1/2  turns.  The 
oven  broil  burner  flame  cannot  be  properly  adjusted 
if  this  conversion  is  not  made.  See  “Adjust  Oven 
Broil Burner Flame” section.

 2.  Reinstall the storage or warming drawer.

 3.  Complete  installation.  See  “Make  Gas  Connection” 

and “Electronic Ignition System” sections.

    Checking  for  proper  cooktop  burner  and  oven  bake 

burner flame is very important. Natural gas flames do 
not have yellow tips.

13