Amana W10196156B Benutzerhandbuch

Food spills containing acids, such as vinegar and tomato, should 
be cleaned as soon as the cooktop, grates and caps are cool. 
These spills may affect the finish.
To avoid chipping, do not bang grates and caps against each other 
or hard surfaces such as cast iron cookware.
Do not reassemble caps on burners while wet.
Do not clean in the Self-Cleaning cycle.
Cleaning Method:

■

Nonabrasive plastic scrubbing pad and mildly abrasive 
cleanser:

Clean as soon as cooktop, grates and caps are cool.

■

Dishwasher (grates only, not caps):

Use the most aggressive cycle. Cooked-on soils should be 
soaked or scrubbed before going into a dishwasher.

■

Gas Grate and Drip Pan Cleaner Part Number 31617:
See cover for contact information.

■

See “Sealed Surface Burners” section.

To avoid damage to the cooktop controls, do not use steel wool, 
abrasive cleansers or oven cleaner.
Do not soak knobs. When replacing knobs, make sure knobs are in 
the OFF position.

On some models, do not remove seals under knobs.
Cleaning Method:

■

Soap and water: 
Pull knobs straight away from control panel to remove.

To avoid damage to the control panel, do not use abrasive 
cleaners, steel-wool pads, gritty washcloths or abrasive paper 
towels.
Cleaning Method:

■

Glass cleaner and soft cloth or sponge: 
Apply glass cleaner to soft cloth or sponge, not directly on 
panel.

■

All-Purpose Appliance Cleaner Part Number 31682 (not 
included):
See cover for contact information.

■

Steel-wool pad

■

For racks that have discolored and are harder to slide, a light 
coating of vegetable oil applied to the rack guides will help 
them slide.

Check that storage drawer is cool and empty before cleaning.
Cleaning Method:

■

Mild detergent

The oven light is a standard 40-watt appliance bulb. Before 
replacing, make sure the oven and cooktop are cool and the 
control knobs are in the off position.

1. Unplug range or disconnect power.

2. Turn the glass bulb cover in the back of the oven 

counterclockwise to remove.

3. Turn bulb counterclockwise to remove from socket.

4. Replace bulb, then bulb cover by turning clockwise.
5. Plug in range or reconnect power.

■

Is the power supply cord unplugged?
Plug into a grounded 3 prong outlet.

■

Household fuse blown or circuit breaker tripped?
Replace the fuse or reset the circuit breaker. If the problem 
continues, call an electrician.

■

Is the main or regulator gas shutoff valve in the off 
position?
See Installation Instructions.

■

Is the range properly connected to the gas supply?
Contact a trained repair specialist or see Installation 
Instructions.

■

Is the oven in self-clean?
Surface burners will not operate during self-clean cycle.

■

Is the control knob set correctly?
Push in knob before turning to a setting.

■

Is this the first time the surface burners have been used?    
Turn on any one of the surface burner knobs to release air from 
the gas lines.

■

Are the burner ports clogged?
See “Sealed Surface Burners” section.