Liebherr CUP(sl) 2221/2721/3021 Benutzerhandbuch

Fire hazard due to refrigerant!

The  refrigerant  R  600a  is  environmentally  friendly  but  flam-

mable. Escaping refrigerant may ignite.

u

Do not damage the piping of the refrigeration circuit.

Fire hazard and danger of damage!

u

Do  not  place  appliances  emitting  heat  e.g.  microwaves,

toasters etc. on the appliance!

Blocked ventilation openings pose a risk of fire and damage!

u

Always keep the ventilation openings clear. Always ensure

that the appliance is properly ventilated!

Risk of damage due to condensate!

u

Do  not  install  the  appliance  directly  alongside  a  further

refrigerator/freezer.

q

In  the  event  that  the  appliance  is  damaged,  contact  the

supplier immediately before connecting to the mains.

q

The floor at the site must be flat and level.

q

Do not install the appliance in a location where it is exposed

to  direct  radiation  of  the  sun,  next  to  a  cooker,  heater  and

similar.

q

Always stand the appliance with its back directly to the wall.

q

The appliance may be moved only when it is empty.

q

Do not install the appliance without assistance.

q

Standard EN 378 specifies that the room in which you install

your  appliance  must  have  a  volume  of  1  m

2

  per  8  g  of  R

600a refrigerant used in the appliance. If the room in which

the  appliance  is  installed  is  too  small,  a  flammable  gas-air

mixture may form in the event of a leakage in the refrigera-

tion circuit. The quantity of refrigerant used in your appliance

is indicated on the type plate on the inside of the appliance.

u

Detach the connecting cable from the rear of the appliance,

removing the cable holder at the same time because other-

wise there will be vibratory noise!

The  stainless  steel  doors  are  finished  with  a  high  quality

surface coating and must not be treated with the enclosed care

product,

as otherwise the surface coating will be damaged.

u

Please only use a soft clean cloth to wipe the coated door

surfaces.

u

Only  use  a  stainless  steel  care  product  on  the  stainless

steel  side  walls,  applying  it  evenly  in  the  direction  of

polishing. Subsequent cleaning will then be easier.

u

Use  only  a  soft  clean  cloth  to  wipe  side  walls  and  door

surfaces with a paint finish.

u

Remove the protective film from the decorative trims.

u

Remove all transit supports.

u

u

Align  the  appliance  so  that  it

stands firmly and on a level by

applying  the  accompanying

spanner  to  the  adjustable-

height  feet  (A)  and  using  a

spirit level.

u

If  the  appliance  is  installed  in  a  very  damp  environment,

condensate may form on the outside of the appliance.

u

Always see to good ventilation at the installation site.

You can change over the door hinges if necessary.
Make sure that the following tools are to hand:

q

Torx® 25

q

Torx® 20

q

Torx® 15

q

Screwdriver

q

Supplied open-ended wrench

q

If necessary, a second person to assist with installation

Risk of injury if the door tips!

u

Take good hold of the door.

u

Set down the door carefully.