Samsung RF4287HABP Benutzerhandbuch
setting up
_07
01 SETTING
UP
Disassemble the refrigerator doors
Be careful not to drop and scratch the doors
while removing the doors.
while removing the doors.
Disassemble the refrigerator doors
1. With the door opened, remove the cap top table
( 1 ) with a fl at-blade screwdriver (-), and close the
door. Remove the 3 screws holding down the top
table ( 2 ) and turn it with several wires connected.
door. Remove the 3 screws holding down the top
table ( 2 ) and turn it with several wires connected.
2. Disconnect one connector ( 3 ) on the right side
door and one connector ( 4 ) on the left side door.
Remove the water line ( 5 ) while pressing the dark
gray color part ( 6 ) of the water line coupler.
Remove the water line ( 5 ) while pressing the dark
gray color part ( 6 ) of the water line coupler.
If a red clip is on the coupler, it must be
removed before removing the tube.
removed before removing the tube.
3. Remove the 3 hex head bolts ( 7 ) attached to
the upper left and right door hinges with a socket
wrench (10mm). Remove the ground screw ( 8 )
attached to the upper left and right door hinges
with a philips screwdriver (+). Remove the upper
left and right door hinges ( 9 ).
wrench (10mm). Remove the ground screw ( 8 )
attached to the upper left and right door hinges
with a philips screwdriver (+). Remove the upper
left and right door hinges ( 9 ).
4. Lift the door straight up to remove.
5. Remove the screw ( 10 ) attached to the lower left
and right door hinges with a philips screwdriver (+).
Remove the 2 hex head bolts ( 11 ) attached to
the lower left and right door hinges with an allen
wrench (3/16”). Remove the lower left and right
door hinges ( 12 ).
Remove the 2 hex head bolts ( 11 ) attached to
the lower left and right door hinges with an allen
wrench (3/16”). Remove the lower left and right
door hinges ( 12 ).
REATTACHING THE REFRIGERATOR
DOORS
DOORS
To reattach the fridge doors, assemble parts in reverse
order.
1. The Water Line must be fully inserted to the center
order.
1. The Water Line must be fully inserted to the center
of transparent coupler (Type A) or the Guide
Lines (Type B) to prevent water leakage from the
dispenser.
Lines (Type B) to prevent water leakage from the
dispenser.
2. Insert the clip in the install pack and check that it
holds the line fi rmly.
WARNING
CAUTION
1
2
4
5
6
3
Red Clip
Red Clip
(1/4")
(1/4")
Socket wrench
Socket wrench
7
8
9
Allen wrench
Allen wrench
12
10
11
Center of Transparent coupler
Center of Transparent coupler
The Guide Lines
The Guide Lines
Dispenser
Dispenser
clip A (1/4”)
clip A (1/4”)
(6.35mm)
(6.35mm)
(6.35mm)
clip A (1/4”)
clip A (1/4”)
(6.35mm)
(6.35mm)
(6.35mm)
Type A
Type A
Type B
Type B
DA68-01922A.indb 07
DA68-01922A.indb 07
2013.3.4 1:32:33 PM
2013.3.4 1:32:33 PM