Samsung RF4267HABP Benutzerhandbuch

 

setting up

CHECKING THE WATER DISPENSER LINE

A water dispenser with a filter is one of the helpful 
features on your new refrigerator. To help promote 
better health, the water filter removes unwanted 
particles from your water. However, it does not sterilize 
or destroy microorganisms. You may need to purchase 
a water purifying system to do that.
In order for the ice maker to operate properly, a water 
pressure of 20~125 psi (138~862 kPa) is required.
Under normal conditions, a 170 cc (5.75 oz.) cup can 
be filled in about 10 seconds.
If the refrigerator is installed in an area with low water 
pressure (below 20psi), you can install a booster pump 
to compensate for the low pressure.
After you have connected the water line, make 
sure the water storage tank inside the refrigerator is 
properly filled. To do this, press the water dispenser 
lever until the water runs from the water outlet.

Water line installation kits are available at extra 
cost from your dealer. We recommend using a 

water line installation kit that contains copper tubing 
and ¼” compression nut.

1.  First, shut off the main water 

supply.

2.  Locate the 

nearest cold 
water drinking 
line and install 
the pipe clamp 
and shut off 
valve.

3.  Connect the water line installation kit to the shut 

off valve.

INSTALLING THE WATER LINE

There are several items that you need to purchase 
to complete this connection. 
You may find these items sold as a kit at your local 
hardware store.

1.  Connect the household water line to the 

assembled compression fitting.

-  If you are using copper tubing, slip the 

compression nut ( 

B ) (not supplied) and ferrule 

(not supplied) on the copper tubing (not supplied) 
as shown.

-  If you are using plastic tubing ( 

B ) , insert the 

molded end (Bulb) of the plastic tubing ( 

B ) into 

the compression fitting.

Do not use without the molded end (Bulb) of 
the plastic tubing ( 

B ).

2.  Tighten the compression nut ( B ) onto the 

compression fitting. 
Do not over-tighten the compression nut ( 

B ) .

Compression

Nut  (1/4”)  

(Assembled)  

Ferrule 

(Not supplied)

Plastic Tubing 
(Assembled)  

Compression Fitting 
(Assembled)

Molded end(Bulb)

Compression nut (B) 
(1/4”) (Not supplied)

or

Copper tubing

(Not supplied)

Plastic tubing (B)
(Not supplied)

Household water supply line

Refrigerator

Use Copper Tubing

Use Plastic Tubing

•  ¼” copper tubing

•  ¼” compression nut (1pc)

•  Ferrule (2pc)

•  ¼” plastic tubing 

→

 Molded end(Bulb)

•  ¼” compression nut (1pc)

CAUTION

DA68-02481A-10.indb   10

13. 4. 25.   �� 2:18