Rose electronic 2xE Benutzerhandbuch
ULTRAMATRIX E-SERIES MANUAL
73
Kernel halt error messages
Message
Description
BAD Address = nn
Kernel memory is corrupt, hardware failure.
Resetting to factory
defaults
defaults
A memory error is detected during a read
from configuration memory. This also
indicates a hardware failure, but the system
may continue to initialize successfully. The
configuration from another Unit should be
saved to this Unit as soon as possible.
from configuration memory. This also
indicates a hardware failure, but the system
may continue to initialize successfully. The
configuration from another Unit should be
saved to this Unit as soon as possible.
Unit Halted
A major error has forced the kernel to stop
processing. The UltraMatrix waits to receive a
kernel or main firmware file from the bottom
board’s serial port using the serial
parameters: 9600, N, 8, 1. Connect the serial
cable supplied with the UltraMatrix as
described in the Serial Port section, start a
terminal emulator and transfer the file using
an ASCII file transfer protocol.
processing. The UltraMatrix waits to receive a
kernel or main firmware file from the bottom
board’s serial port using the serial
parameters: 9600, N, 8, 1. Connect the serial
cable supplied with the UltraMatrix as
described in the Serial Port section, start a
terminal emulator and transfer the file using
an ASCII file transfer protocol.
Kernel is bad, load
new kernel through
serial port.
new kernel through
serial port.
The UltraMatrix waits to receive a kernel or
main firmware file from the bottom board’s
serial port using the serial parameters: 9600,
N, 8, 1. Connect the serial cable supplied
with the UltraMatrix as described in the Serial
Port Section, start a terminal emulator and
transfer the file using an ASCII file transfer
protocol.
main firmware file from the bottom board’s
serial port using the serial parameters: 9600,
N, 8, 1. Connect the serial cable supplied
with the UltraMatrix as described in the Serial
Port Section, start a terminal emulator and
transfer the file using an ASCII file transfer
protocol.
Checksum error
The kernel writes this message at power up
when a memory error is detected during a
read from program memory.
when a memory error is detected during a
read from program memory.