Zebra Technologies 105SL Plus Benutzerhandbuch

Printer Configuration and Adjustment
Calibrate the Ribbon and Media Sensors Manually

P1056468-002  

7/3/13

Use the calibration procedure in this section when necessary to calibrate the printer based on 
the media and ribbon that you are currently using. Manual calibration is recommended 
whenever you are using pre-printed labels (or label backing) or if the printer will not correctly 
auto calibrate.

• For issues that may be resolved by sensor calibration, see 

.

• For a summary of the options for initiating calibration, see 

With the printer in the Ready state, initiate media and ribbon calibration through the 
printer’s display:

Navigate to the following parameter. See 

 for 

information about using the control panel.

Press RIGHT SELECT to select 

START

. 

The printer does the following:

•

The STATUS light and SUPPLIES light flash yellow once. 

•

The PAUSE light blinks yellow.

•

The control panel displays:

LOAD BACKING

Follow the calibration procedure exactly as presented. All of the steps must be 

performed even if only one of the sensors requires adjustment. You may press and hold 

CANCEL

 at any step in this procedure to cancel the process.