Ricoh AP610N Benutzerhandbuch

Paper and Other Media

Loading Envelopes

As there are many kinds of envelopes,
be sure to check if those to be used are
supported by this printer.

Reference

For more information about enve-
lopes, see p.10 “Envelopes”.

Important

❒ Even if the optional envelope feed-

er is not installed, you can select
envelope sizes for Tray 2 and Tray
3 using the control panel. Howev-
er, you cannot load envelopes until
the optional envelop feeder unit is
installed.

❒ To install the envelope feeder unit,

the optional paper feed unit must
be installed. See “Attaching Enve-
lope Feeder Unit Type 610”, Setup
Guide.

Loading envelopes onto the Bypass Tray

Reference

With the bypass tray, you can load
up to 10 envelopes at the same
time. For more information about
envelopes, see p.10 “Envelopes”.
To open and close the bypass tray,
see p.19 “Opening and Closing the
Bypass Tray”

Load envelopes until they stop,
with the print side up and the
sides of the flaps on the left as
shown below.

Important

❒ Confirm that the envelope flaps

are securely folded down, and
that there is no air inside the en-
velopes.

Note

❒ Confirm that the top of the stack

is not higher than the limit mark
on the side guides.

❒ Do not push the stack of enve-

lopes with too much force.

Slide the side guides against the
edge of the envelope stack.

Note

❒ Confirm that the edges of enve-

lopes fit under the side guides.

ZKGY411E

KirP4GB_Mainte-F6_FM_forPaper.book Page 24 Thursday, May 12, 2005 11:48 AM