Ricoh AP610N Benutzerhandbuch

Troubleshooting

58

Reset Toner

Cartridge

The toner cartridge is not set 
correctly.

Set the toner cartridge correctly.

See p.29 “Replacing the Toner Car-
tridge”.

The toner cartridge is not set in-
stalled.

If the cartridge is installed, close the 
front cover and turn the off power 
switch and then on. If the message ap-
pears again, contact your sales or 
service representative.

Reset Tray #

or Form Feed

The indicated paper input tray 
is not set correctly, or not set.

#: tray number

Set the indicated paper input tray cor-
rectly.

Resetting Job...

The print job is being reset.

Wait for a while.

ROM Update

Waiting for Data

The printer is waiting for up-
dated data.

Don't turn off the printer while it is 
waiting for data.

ROM Update

Receiving Data

The printer is receiving updat-
ed data.

Don't turn off the printer while it is re-
ceiving data. 

SC XXX-X

Power Off On

If Error Reoccur

Call Service

An error has occurred.

Turn the power off, and then on. If the 
message appears again, contact your 
sales or service representative.

Supply order

failed

Supply order has failed.

The use is required to reset the job.

SD authenticatn

failed

Authentication for the SD card 
has failed.

Turn the power off, and then on. If the 
message appears again, contact your 
sales or service representative.

Setting change

in process

A setting change is currently in 
process on the computer side.

The user must wait until the change is 
complete.

Setting changed

Restart Printer

 [RAM Disk] or [Notify by E-mail] 
setting has been changed.

Restart the printer so the new settings 
can take effect.

SSID not entered

This message appears if the 
SSID has not been entered.

Enter the SSID.

Toner is almost

empty

The toner is almost run out.

Prepare a new toner cartridge. If the 
image density gets too light, replace 
the toner cartridge with a new one.

See p.29 “Replacing the Toner Car-
tridge”.

Update Mode Err.

Power Off On

The printer has failed to start 
updating data.

Turn the power off, and then on to re-
start.

Waiting...

The printer is waiting for the 
next print job.

Wait a while.

Warming up...

The printer is warming up or 
toner is being supplied.

Wait until the panel display change 
the [Ready].

KirP4GB_Mainte-F6_FM_forPaper.book  Page 58  Thursday, May 12, 2005  11:48 AM