Ricoh AP610N Benutzerhandbuch

Printer Does Not Print

59

Is the power on ?

Confirm that the cable is securely plugged into the power outlet 
and the printer.

Turn on the power.

Does the Online indicator 
stay on ?

If not, Press the {Online} key to light it.

Does the Alert indicator 
stay red ?

If so, check the error message on the display and take the required 
action.

Is paper loaded ?

Load paper into the paper tray or onto the bypass tray.

Can you print a configura-
tion page ?

If you cannot print a configuration page, it probably indicates a 
printer malfunction. Contact your sales or service representative.

See “Test Printing”, Setup Guide.

Is the interface cable con-
nected securely to the 
printer and the computer ?

Connect the interface cable securely. If it has a fastener, fasten it 
securely as well.

Are you using the correct 
interface cable ?

The type of interface cable you should use depends on the compu-
ter you use. Be sure to use the correct one. 

If the cable is damaged or worn, replace it with a new one.

Is the Data In indicator 
blinking or lit after starting 
the print job ?

If not blinking or lit, the data is not being sent to the printer. 

❖ If the printer is connected to the computer using the in-

Check the port connection setting is correct. For details about 
checking the port connection, see p.61 “Checking the port con-
nection”.

❖ Network Connection

Contact your network administrator.

How is the signal strength 
when using the wireless 
LAN ?

❖ Ad hoc Mode or 802.11 Ad hoc Mode

Either move to a location where the signal is good, or remove 
obstructions.

❖ Infrastructure Mode

Check the signal status from the [Maintenance] menu on the 
control panel. If the signal is poor, either move to a location 
where it is good, or remove obstructions.

How is the signal strength 
when using Bluetooth ?

Try the following:

• Check the Bluetooth interface unit is installed properly.

• Check there are no obstructions between computer, printer 

and other devices.

• Change the location of the computer.

• Change the location of the printer.

KirP4GB_Mainte-F6_FM_forPaper.book  Page 59  Thursday, May 12, 2005  11:48 AM