RAD Data comm Modular Access Device with Integrated Router Benutzerhandbuch
FCD-IPM Installation and Operation Manual
Appendix B Boot Manager
The Boot Manager Menu
B-5
Set Baud Rate
Select this option to set the device’s baud rate to either 9.6, 19.2, 38.4, 57.6 or
115.2 kbps. For software download, it is recommended to use the highest rate
possible, i.e., 115.2 kbps. The baud rate must be higher than 9.6 kbps to enable
downloading.
115.2 kbps. For software download, it is recommended to use the highest rate
possible, i.e., 115.2 kbps. The baud rate must be higher than 9.6 kbps to enable
downloading.
Modem
Download Code
(115.2) kbps.
Control Port
FCD-IPM
Figure B-3. Setting the Baud Rate
Change your terminal baud rate and press Enter several times to ensure that the
device identifies the new value.
device identifies the new value.
Windows 95 terminal emulator, HyperTerminal, has the following bug: after
changing baud rate the status line presents the new value, but this value does not
come into effect unless you perform the disconnect and connect commands
immediately after performing the change.
changing baud rate the status line presents the new value, but this value does not
come into effect unless you perform the disconnect and connect commands
immediately after performing the change.
Exit
Select this option to exit the Boot Manager menu and perform Boot/RESET FCD-
IPM.
If the Boot Manager is idle for more the two minutes, exit is performed
automatically.
IPM.
If the Boot Manager is idle for more the two minutes, exit is performed
automatically.
Note