Patton electronic 3120 Benutzerhandbuch

Model 3120 RAS Getting Started Guide

Cable installation

2. Rotate the power cable retainer clip so it secures the power cable plug in the IEC-320 connector as shown 

Figure 6. Power cable retainer clip

3. Repeat steps 1 and 2 to install the remaining power cable.

This section describes configuring the RAS to use DC power. Do not connect the remaining end of the power 
cables to the DC power source. 

Figure 7. DC connector, - DC and + DC Input view

1. Connect the earth ground of the DC source to the grounding stud on the RAS as described in the follow-

2. Remove approximately 

1/4

-inch of insulation from the end of each wire.