Scientific Atlanta 573480 Benutzerhandbuch
573497 Rev B
9
Reprogramming your cable device button
Your AllTouch Remote Control is already set up to operate a Scientific-
Atlanta home terminal/HCT. If your remote control loses its code for
the home terminal/HCT, you need to reprogram your cable device
button. Follow the instructions below.
Atlanta home terminal/HCT. If your remote control loses its code for
the home terminal/HCT, you need to reprogram your cable device
button. Follow the instructions below.
Notes:
• Not all cable functions work with older Scientific-Atlanta home
• Not all cable functions work with older Scientific-Atlanta home
terminals.
• In the cable mode, the VOL button will not control the volume
through the home terminal/HCT unless you program it to do so.
See Volume Lock on page 14. The Volume Lock defaults to
TV mode.
See Volume Lock on page 14. The Volume Lock defaults to
TV mode.
The code for your brand of home terminal/HCT is 491.
1. Press and release
CBL
, then hold down
SET-UP
until
the red light blinks twice.
Note: You may need to wait a few seconds for the
red light to blink twice.
red light to blink twice.
2. Enter
4
9
1
– the red light should blink twice
again. (If the red light does not blink twice, return
to step 1 and try again.)
to step 1 and try again.)
3. Point your AllTouch Remote Control at your home
terminal/HCT and press
POWER
.
4. Did your home terminal/HCT turn off (or on)?
• If yes, you are finished setting up your home
terminal/HCT.
• If no, go to step 5.
Note: All VCR functions (
PLAY
,
FF
, etc.) also work in CBL
mode. To record a program, press
REC
twice.
5. If your home terminal/HCT did not respond, repeat steps 1
through 4.
6. If your home terminal/HCT still did not respond, contact your
service provider.
VCR
1
4
7
2
5
8
0
3
6
9
AUX
V
O
L
O
L
S
E
L
E
C
T
REW
PAUSE
REC
STOP
PLAY
FF
SET-UP
BYPASS
MENU
INFO
PPV
PREV. DAY
NEXT DAY
MUTE
LA
ST
FAV
POWER
B
A
C
TV
CBL
C
H
H
T6057
SET-UP
CBL
GUIDE