Scientific Atlanta 573480 Manual Do Utilizador

573497 Rev B

9

Your AllTouch Remote Control is already set up to operate a Scientific-
Atlanta home terminal/HCT. If your remote control loses its code for
the home terminal/HCT, you need to reprogram your cable device
button. Follow the instructions below.

Notes:
• Not all cable functions work with older Scientific-Atlanta home

terminals.

• In the cable mode, the VOL button will not control the volume

through the home terminal/HCT unless you program it to do so.
See Volume Lock on page 14. The Volume Lock defaults to
TV mode.

The code for your brand of home terminal/HCT is 491.

1. Press and release 

, then hold down 

 until

the red light blinks twice.

Note: You may need to wait a few seconds for the
red light to blink twice.

2. Enter 

 

 

 – the red light should blink twice

again. (If the red light does not blink twice, return
to step 1 and try again.)

3. Point your AllTouch Remote Control at your home

terminal/HCT and press 

POWER

.

4. Did your home terminal/HCT turn off (or on)?

• If yes, you are finished setting up your home

terminal/HCT.

• If no, go to step 5.

Note: All VCR functions (

, 

, etc.) also work in CBL

mode. To record a program, press 

 twice.

5. If your home terminal/HCT did not respond, repeat steps 1

through 4.

6. If your home terminal/HCT still did not respond, contact your

service provider.

VCR

AUX

TV

CBL

T6057