Sterling 882.000254.00 Benutzerhandbuch

7/50D Plus or 7/50D Controller 

Chapter 3:  Installation 

24 

Connecting the Controller to the Network 
To connect the controller to the network, make sure that the KwikLink connector is properly 
installed on the flat grey data cable. To connect: 

1.  Attach the keyed round connector to the terminal of the controller marked 

NETWORK NO. 1. Tighten the cord grip ring until snug. 

2.  Align the square connector of the grey drop cable so the cable leads down from the 

connector. Evenly press the square connector onto the top of the KwikLink 
connector. It should make two audible snaps when properly seated. 

3.  Dress the excess cable with cable ties so it does not interfere with operation and gives 

a pleasing appearance. 

After selecting a location and installing the remote interface, connect it to the main controller: 

1.  Determine the length of blue remote cable you need, and cut it to length. 

2.  Run the cable from the remote interface to the main controller, neatly dressing the 

cable with cable ties so it does not interfere with system operation and to give it a 
neat appearance.  

3.  Attach connectors at each end, following the connector manufacturer’s instructions. 

4.  Attach one connector to the remote interface terminal marked REMOTE DISPLAY. 

Tighten the cord grip ring until snug. 

5.  Attach the other connector to the terminal of the controller marked REMOTE 

DISPLAY. Tighten the cord grip ring until snug.