Sterling 882.000254.00 Benutzerhandbuch
7/50D Plus or 7/50D Controller
Chapter 3: Installation
33
Connecting Central Alarms to the Network
Make sure that all previous installation steps have been done first before starting this task.
First, determine where the best location for central alarms should be, and install the
alarm module(s) there. You’ll use two yellow patch cords to connect.
Make sure that all previous installation steps have been done first before starting this task.
First, determine where the best location for central alarms should be, and install the
alarm module(s) there. You’ll use two yellow patch cords to connect.
To connect an alarm module to the network:
1. Attach one connector of the first yellow patch cord to the terminal on the alarm
module. Tighten the cord grip ring until snug.
2. Attach the other connector to the upper right terminal of the ArmorBlock. Tighten
the cord grip ring until snug.
Figure 16: Proper Central Alarm Connections
Grey Network Flat Cable
Remote Alarm
Push to Silence Button
Black Power Flat Cable
Vacuum Tube
ArmorBlock Mounting
Plate Kit - Part
No. A0556696
4 Input / 4 Output ArmorBlock
Part No. A0558296
ArmorBlock Base
Part No. A0555191
Yellow Patch Cord, 20 ft. (6 m)
Part No. A0555190
Yellow Patch Cord, 20 ft. (6 m)
AEC Part No. A0555190
3. Attach one connector of a yellow patch cord to the terminal on the alarm silence
switch module. Tighten the cord grip ring until snug.