Venturer PLV76176 Benutzerhandbuch

E - 1

•  Do not use this unit in places which are extremely

hot, cold, dusty or humid.

•  Do not restrict the air flow of this unit by placing it

somewhere with poor air flow, by covering it with

a cloth, by placing it on bedding or carpeting.

•  When connecting or disconnecting the AC power

cord, grip the plug and not the cord itself. Pulling

the cord may damage it and create a hazard.

•  When you are not going to use the unit for a long

period of time, disconnect the AC power cord.

•

When left in a heated room where it is warm and

damp, water droplets or condensation may form

inside the equipment. When there is condensation

inside the unit, the unit may not function normally.

Let the unit stand for 1-2 hours before turning the

power on or gradually heat the room and let the

unit dry before use.

The rating plate is located on the rear of unit.

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1)

This device may not cause harmful interference, and

(2) this device must accept any interference received,

including  interference  that  may  cause  undesired

operation.
This unit has been tested and found to comply with the

limits for a Class B digital device, pursuant to Part 15

of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential installation. This unit generates, uses and

can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause

harmful interference to radio communication. However,

there is not guarantee that interference will not occur in

a particular installation. If this unit does cause harmful

interference to radio or television reception, which can

be determined by turning the unit off and on, the user is

encouraged to try to correct the interference by one or

more of the following measures:
-  Reorient or relocate the receiving antenna.

-  Increase  the  separation  between  the  unit  and

receiver.

-  Connect the unit into an outlet on a circuit different

from that to which the receiver is connected.

-  Consult  the  dealer  or  an  experienced  radio/TV

technician for help.

-  Shielded  cables  must  be  used  with  this  unit  to

ensure compliance with the Class B FCC limit.

-  This  television  receiver  provides  display  of

television  closed  captioning  in  accordance  with

Section 15.119 of the FCC rules.

The lightning flash with arrowhead symbol,

within an equilateral triangle, is intended to

alert the user to the presence of uninsulated

“dangerous  voltage”  within  the  product’s

enclosure  that  may  be  of  sufficient  magnitude  to

constitute a risk of electric shock to persons.

The exclamation point within an equilateral

triangle  is  intended  to  alert  the  user  to

the  presence  of  important  operating  and

maintenance (servicing) instructions in the

literature accompanying the appliance.

•  DANGER  OF  EXPLOSION  IF  BATTERY  IS

INCORRECTLY  REPLACED.  REPLACE  ONLY

WITH THE SAME OR EQUIVALENT TYPE.

•  USE  OF  CONTROLS  OR ADJUSTMENTS  OR

PERFORMANCE  OF  PROCEDURES  OTHER

THAN  THOSE  SPECIFIED  MAY  RESULT  IN

HAZARDOUS RADIATION EXPOSURE.

The  symbol  for  Class  II

(Double Insulation)

•  To reduce the risk of fire or shock hazard, do not

expose this unit to rain or moisture.

•  The  mains  plug  of  apparatus  should  not  be

obstructed OR should be easily accessed during

intended use.

•  The  unit  shall  not  be  exposed  to  dripping  or

splashing  and  that  no  objects  filled  with  liquids,

such as vases, shall be placed on unit.

•  In  order  to  disconnected  the  unit  from  the

mains  completely,  the AC  power  cord  should

be  disconnected  from  the  mains  socket  outlet

completely.

•  Battery  shall  not  be  exposed  to  excessive  heat

such as sunshine, fire or the like.

WARNING:

•  Changes or modifications to this unit not expressly

approved  by  party  responsible  for  compliance

could void the user authority to operate unit.

Equipment  tested  for

compliance as a complete

unit

PLV76176S7_IB_UL_090723.indd   1

7/24/2009   11:52:40