Venturer PLV76176 Benutzerhandbuch

E - 3

Before turning on your television set for the first time, be sure to place it on a solid stable surface. To avoid

danger, do not expose the TV to water, or a heat source (e.g. lamp, candle, radiator). Do not obstruct the

ventilation grid at the rear and be sure to leave sufficient gaps around the unit as shown.

1. Connect  a  TV  antenna  or  a  CATV  cable  to  the Antenna

Terminal on rear of TV.

2. Connect the power cord.

3. Press the

 / ON button to turn on the unit.

4. Press the   or   button to select “Yes” or “No”, then press the

ENTER button to confirm.

5. The unit will enter TV setting screen. Press the   button to

highlight Auto Scan, then press the

ENTER button to confirm.

6. The unit will enter auto scan setting screen. Press the   button

to highlight Cable System, then press the   or   button to

choose the desired cable system (We recommend you pick

“AUTO”, however you might find you get improved results using

“STD”, “IRC” or “HRC” - these are different standards used

by various Cable Systems.). Then use the   button to move

the highlight bar on Start to Scan and press

ENTER button to

start. The unit will take a few minutes to finish auto scan and

all scanned channels will be stored automatically.

The first time you turn on the unit, the unit will enter the setup mode. You can easily follow the prompt

message on the screen to complete basic TV settings.

Make  sure  the  TV  antenna  or  CATV  cable  has  been  connected  properly  to  the

TV ANTENNA input jack on the rear of the system.

PLV76176S7_IB_UL_090723.indd   3

7/24/2009   11:52:42