Honeywell HRDPX Benutzerhandbuch
Setup
______________________________________________________________________________________________
50
50
Client Configuration
Configure general remote access.
REMOTE PORT – Use this port number when configuring remote access
software. The default port is 4000 but can be changed.
software. The default port is 4000 but can be changed.
WEB PORT – Used for remote connections using a web browser. This port
should be open on the router. Default web port is 80.
should be open on the router. Default web port is 80.
REMOTE CONFIG – Enable to allow an administrator to change configurations
using remote access software.
using remote access software.
TCP MTU – Set network bandwidth. If the network is low speed, set this value
as the network (aka. Bandwidth Throttling).
as the network (aka. Bandwidth Throttling).