RGB Spectrum 201 Benutzerhandbuch

. . . . .

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .

The DGy 201 can be controlled from the 10/100 BASE-T Ethernet port 
using a command line interface (Telnet) or a standard web browser. The 
same set up procedure is used for either type of control. Your DGy 201 
can be connected to a standard LAN or directly as a peer-to-peer 
connection. Network settings must be set prior to using it in either 
configuration.

The following topics are discussed in this section:

•

•

•

. . . . . . . . . 

When connecting systems via Ethernet, the setup of communications 
parameters is automatic. However, because this is a network 
connection, a unique address (known as the IP address) is required. 

For proper operation, DGy 201 requires a fixed IP address (also known 
as a “static” IP address). At the factory, DGy 201 is programmed with a 
default IP address (192.168.1.200), but this address must be changed if 
you want to use your DGy 201 on a network. 

Important

Consult your network administrator to obtain a valid 
IP address before commencing the network setup 
procedure.

S

Recommendation: If you want to use DGy 201 on a Local Area 
Network (LAN), change the unit’s IP address before putting it on 
the network. This can be accomplished in one of two ways:

~

Use the serial port to change the unit’s IP address. 
Refer to the “

” section 

below.

~

Connect DGy 201 directly to a PC using DGy 201’s 
Ethernet port. Refer to the “

” section (page 144) for details.