Samsung SVR-1670 Benutzerhandbuch

Digital Video Recorder        User Guide

Digital Video Recorder        User Guide

A

A

D

B

C

C

B

D

5. Connect the SMPS (switched mode power supply) power cable.

6. Close the upper cover on the SVR-1670, and then reconnect all devices that were removed for

the hard drive installation. 
Now, it is time to configure and activate the hard disk drive.

Figure 3.6.5 Connecting SMPS Power Cable (Change the Image)

Figure 3.6.6 The SVR-1670 Connected with Maximum Number of HDDs

To enable the newly attached hard disk drive, you must change its availability to " O " on the
SVR-1670’s Disk Manager menu.
1. From the OSD, select the System Settings menu.
2. Select the Disk submenu, and then, on it, select Disk Manager. 

- The newly installed hard disk drive appears in the list along with O and X under the State

category.

3. To change to Enabled status, select the hard disk drive to connect and then press ESC to exit

the Disk Selection menu. To enable the hard disk drive, select Add and then press Enter. You
can add the hard disk drive to store data.

Figure 3.6.7 Disk Manager Menu Showing Disabled Hard Disk Drive

Figure 3.6.8 Disk Manager Menu Showing Enabled Hard Disk Drive