DISH Network 138410 Benutzerhandbuch
Page 75
Troubleshooting Tools
Page 75
Note
: If you have the receiver connected to a DSL (Digital Subscriber Line)
phone line, it may cause this test to fail. If so, you will need to install a DSL
filter between the receiver and the phone jack on the wall. You can get a
DSL filter from your Internet Service Provider or a local electronics parts
store.
filter between the receiver and the phone jack on the wall. You can get a
DSL filter from your Internet Service Provider or a local electronics parts
store.
1. Press the MENU button.
2. Select the
System Setup
option.
3. Select the
Diagnostics
option.
Point Dish and Check Switch
The
Point Dish
and
Check Switch
screens are helpful to the Customer
Service Representatives. You may be asked to display these screens when
you call DISH Network. Even though there are items that can be changed,
only change them when specifically directed by a Customer Service
Representative.
you call DISH Network. Even though there are items that can be changed,
only change them when specifically directed by a Customer Service
Representative.
1. Press MENU.
2. Select
System Setup
.
3. Select
Installation
.
4. Select
Point Dish
. This screen shows you information to help
maximize your satellite signal. The bar at the bottom of the screen tells
you the signal strength. Green is a good signal, while red indicates the
signal is not acceptable or is from the wrong satellite.
you the signal strength. Green is a good signal, while red indicates the
signal is not acceptable or is from the wrong satellite.
5. Select
Check Switch
to display the
Installation Summary
screen. The
Installation Summary
screen tells you if you are receiver signals from
the satellites and which multi-dish switches you have installed, if any.
6. Select
Test
only if directed by the Customer Service Representative.
7. Select
Done
.