KVH Industries V7 Benutzerhandbuch

h. Gently flare the braid with your fingers (see

i. Insert the end of the cable into the connector

body until the dielectric is firmly seated

all braid wires remain on the outside of the

connector.

j. Trim any excess braid (see Figure 59), if

necessary. The braid should assemble flush to

within 1/16" (1.6 mm) of the connector

shoulder.

k. Slide the ferrule over the braid until it is flush

against the connector shoulder (see

Figure 57: Flaring the Braid

Figure 58: Pushing On the Connector

Figure 59: Trimming the Braid

Figure 60: Sliding the Ferrule Over the Braid

Continued

Terminating LMR-400-75 Cable