KVH Industries V7 Benutzerhandbuch

31

l. Using an appropriate crimp tool (either the 

CT-400/300 or the HX-4 with Y1719 dies), 

crimp the ferrule in place (see Figure 61). 

Crimp as close to the connector body as 

possible. 

m. Crimp the ferrule again, but further back 

from the connector. However, be careful not 

to crimp the cable jacket.

n. Slide the heat shrink sleeve over the 

connector body and heat it to compress it into 

place (see Figure 62). When you are done, the 

heat shrink should extend from the rear of the 

connector to the cable jacket. This forms a 

weather-tight seal.

o. Using a multimeter or similar device, check 

the continuity of the cable.

Figure 61:  Crimping the Ferrule onto the Cable

Figure 62:  Applying the Heat Shrink Tubing

Continued 

Terminating LMR-400-75 Cable

B